I have a question about how to filter on personality. PER_LINUX = 0x0000, PER_LINUX_32BIT = 0x0000 | ADDR_LIMIT_32BIT, PER_LINUX32 = 0x0008, PER_LINUX32_3GB = 0x0008 | ADDR_LIMIT_3GB, So if I want to audit a particular syscall, chmod for example, in a 32bit executable, is this the correct usage?: "auditctl -a exit,always -S chmod -F pers=0x0008" I've created a simple test that executes the __NR_chmod syscall and compiled it 32bit (out put from "file": ELF 32-bit LSB executable, Intel 80386, version 1 (SYSV), for GNU/Linux 2.2.5, dynamically linked (uses shared libs), not stripped") When I add the above rule, it is accepted by auditctl and is listed as: "AUDIT_LIST: exit always pers=8 (0x8) syscall=chmod" But I do not see any audit records generated. Also, if I add the rule "auditctl -a exit,always -S chmod -F pers=0x0000" It is accepted by auditctl and is listed as: "AUDIT_LIST: exit always pers=0 syscall=chmod" And I do see audit records generated in /var/log/messages. Note: "pers" is not displayed in the record. I wasn't sure if 0x0008 was the correct value to capture syscalls compiled in 32bit mode. So I tried this auditctl filter next: "auditctl -a exit,always -S chmod -F pers!=0x0000" It is accepted by auditctl and is listed as: "AUDIT_LIST: exit always pers!=0 syscall=chmod" Again, no audit records are generated. In the same personality.h, I found: ADDR_LIMIT_32BIT = 0x0800000, So I also tried: "auditctl -a exit,always -S chmod -F pers=0x0800000" It is accepted by auditctl and is listed as: AUDIT_LIST: exit always pers=8388608 (0x800000) syscall=chmod But again, I don't see any audit records generated. -debbie