Re: [PATCH] Add auditd listener and remote audit protocol
Hi LCB,
I hope I answer u correctly...
I would look in your /etc/audisp/audisp-remote.conf file and note the
port you communicate on, as an alternate you can grab the port with
"lsof -i -nP" or "netstat -taupe". Then you can use tcpdump to watch
the connections.
#tcpdump -i eth0 port 1001 --> or what ever port you have setup to
the remote data on and the correct nic.
Sounds like this could help u out.
Norman Mark St. Laurent
Conceras | Chief Technology Officer and ISSE
Phone: 703-965-4892
Email: mstlaurent(a)conceras.com
Web: http://www.conceras.com
Connect. Collaborate. Conceras.
LC Bruzenak wrote:
On Thu, 2008-08-14 at 19:31 -0500, LC Bruzenak wrote:
> On Thu, 2008-08-14 at 20:27 -0400, Steve Grubb wrote:
>
>> On Thursday 14 August 2008 20:22:24 LC Bruzenak wrote:
>>
>>> I think you have a good point - this is the first cut and maybe
>>>
> later on
>
>>> institute a "replay daemon" or something which can send events on
>>> reconnect.
>>>
>> Note that all audispd plugins take their input from stdin. At the
>>
> worst, if
>
>> you had the time hacks, you could
>>
>> ausearch --start <time> --end <time> --raw | /sbin.audisp-remote
>>
>> -Steve
>>
Steve,
I have been doing this but I really cannot tell if the audisp-remote
connection succeeds; it returns "0" either way.
Would there be an easy way to return a non-zero failure indicator?
Thx,
LCB.